The main function of the safety light curtain is to "protect the machine and the personal safety of the operator".
In the manufacturer to choose the model of the safety light curtain, the next step is to install and debug, how to install and debug the safety light curtain:
The first step: first determine the installation location, according to different mechanical equipment (such as punch, injection molding machine, hydraulic press installed on the front side).
Step 2: Determine the location and punch the hole
The third step: the general safety light curtain will have the standard bracket of the manufacturer, then the bracket is installed on the sliding slot of the safety light curtain and then tightened, and finally installed on the opposite hole, it will do.
The fourth step: the last is the wiring, cable. After the line is connected, it must be arranged. In order to avoid the line and hinder the work, it needs to be fixed together.
How to debug, in fact, debugging can be divided into: determine the power supply voltage (according to the voltage used by the safety light curtain), power down, light, second inspection, and finally complete debugging:
When confirming that the safety light curtain is energized normally, the most important one is to check the light. When blocking a beam of light, the light of the receiver is turned from green to red, and when the light is illuminated, the receiver is lit green.
Finally, the indicators on the receiver and controller are the same as in the “Protect” state, indicating that the photo protector is in a normal state.
The above is a small series of explanations, if there are other places that do not understand, feel free to contact us! !